With the advent of the industrial era, the strong market demand for solenoid valves is growing day by day, and they have become one of the key products in fluid control automation. According to their operating structure, solenoid valves are mainly divided into two most commonly used categories: pilot‑operated solenoid valves and direct‑acting solenoid valves. Improper selection may lead to malfunction of the solenoid valve and also affect the safety of the working conditions. This article provides a detailed introduction to the differences and characteristics between the two types to help with better application. Please refer to the content below.

Direct‑Acting Solenoid Valves
Direct‑acting solenoid valves are generally used in small‑bore, low‑pressure applications. When opening, they do not require medium pressure and can start at zero pressure. Therefore, their starting speed is faster than that of pilot‑operated solenoid valves, making them especially suitable for applications requiring quick shut‑off.
Features:Power consumption is higher than pilot‑operated types, usually 5–20W. Frequent energization may easily burn out the coil. However, they feature simple control and a wide range of applications. They operate normally under vacuum, negative pressure, and zero‑pressure conditions, but the nominal diameter is generally no more than 50 mm.
Pilot‑Operated Solenoid Valves
Pilot‑operated solenoid valves are generally used in large‑bore, high‑pressure applications. When opening, the inlet pressure must not be lower than 0.03 MPa; pilot pressure is required, otherwise the valve cannot open. In addition, pilot‑operated solenoid valves have greater flow capacity than direct‑acting types, with a typical Cv value above 3. They require high purity of compressed air, whereas direct‑acting valves have less stringent requirements.
Features:Small electromagnetic head, low power consumption (0.1–0.2W), allowing frequent and long‑term energization without coil burnout, and energy‑saving. The upper limit of fluid pressure range is high, and they can be installed flexibly (customizable). However, they must meet the fluid pressure difference condition. Impurities in liquid may easily block the pilot orifice, so they are not suitable for liquid service.
Differences and Applications of Direct‑Acting and Pilot‑Operated Solenoid Valves
Pressure resistance: Pilot‑operated solenoid valves withstand higher fluid pressure than direct‑acting types.
Response time: Direct‑acting solenoid valves have faster starting speed and are mostly used for quick shut‑off. Pilot‑operated valves open the small pilot valve first, then the main valve; direct‑acting valves open the main valve directly.
Flow capacity: Pilot‑operated solenoid valves have higher flow capacity, generally with Cv values above 3, while direct‑acting valves usually have Cv values below 1.
Power and loss: Direct‑acting solenoid valves have higher power consumption and losses.
Medium cleanliness requirement: Pilot‑operated solenoid valves have higher requirements for medium purity, while direct‑acting valves are less strict.
If you still have difficulty understanding the working principles and functions of these two solenoid valves, please contact our technical department. Our staff will assist with product selection based on your working conditions and explain the structure, principle, and application requirements.